欢迎光临依元素科技有限公司!

首页 > 产品展示 > 解决方案
PCIe PIPE Slowdown Core

PCIe PIPE Slowdown Core

产品型号 :

2018-07-04 浏览次数: 75
  • 产品介绍
  • 特色
  • 产品规格
  • 实物图片
  • 资源



The process of prototyping PCIe systems with FPGAs is easier if the frequency is reduced to a number comfortably within an FPGAs capability. This is troublesome in PCI Express systems since the clocks are generated using high performance PLLs and cannot be readily throttled. So PIPE interfaces in FPGA prototypes are required to run at 125MHz/250MHz for GEN1 PCIe and at 250MHz/500MHz for GEN2 and these are too fast. The Dini Group PCIe PIPE Slowdown Core enables IP interfacing to the standard Intel PIPE at a much slower frequency.




Connecting the Slowdown Core between the user's design and the PCIe serial interface allows the user to build a design that runs at 31.25 - 125MHz, instead of the full speed of 250 MHz (or 500MHz), and still maintain full PCIe functionality. The Slowdown Core can be configured with an 8-bit or 16-bit PIPE interface, and has support for 1, 4, and 8-lane configurations.

The Slowdown Core will automatically handle polarity inversion and allows the user to enable or disable: 1)the generation and filtering or skip-ordered sets, 2)byte-alignment across the active lanes of the PIPE interface, and 3)LFSR scrambling.

The Dini Group PCIe Slowdown Core is only available in Dini Group PCIe boards, and licensing is done via an encryption key that is programmed at the factory.

Source code is provided for the Slowdown User I/O module to interface to the Slowdown Core.



l IP block that throttles a PHY Interface to a slower frequency

Ø Easier prototyping of PCIe logic

Ø    Frequency division by a factor 2 to a maximum of 8

Ø    250MHz/125MHz -> 31.25MHz

l    PCIe GEN1 (2.5Gb/s) and PCIe GEN2 (5.0Gb/s)

l    1, 4, or 8-lanes

Ø    8-bit or 16-bit per lane

l    Signal Interface identical to the Intel PIPE specification

Ø    PHY Interface for the PCI Express Architecture (Version 2.00)

Ø    No user MAC interface modifications required

l    Support for power management and power state transition

Ø    L0, L0s, L1, L2, L3

Ø    Beacon signaling (L2 -> L0)

Ø    Receiver detection

l    Simulation models and example interface code provided


资料下载

联系我们

  • 025-58800523

    电话:025-58800523

  •  sales@e-elements.com

    邮箱:sales@e-elements.com

  • 南京市高新区星火路17号集成电路产业中心B座1003

    地址:南京市高新区星火路17号集成电路产业中心B座1003

×
×